What temperature for PETG on the S5?

Recommended nozzle temperature for PETG on the S5 is 235°C (range: 220–250°C). Bed temperature: 80°C.

What bed temperature for PETG on the S5?

Set the S5 bed to 80°C for PETG. The acceptable range is 75–90°C.

Use 0.5 mm retraction distance at 35 mm/s for PETG on the S5.

Set the part-cooling fan to 50% for PETG on the S5. Minimum speed: 20%.

Print PETG at 235°C nozzle and 80°C bed on the S5.Fan speed 50%, retraction 0.5mm, print speed 40mm/s.

Nozzle temp235°C220–250°C range

Bed temp80°C75–90°C range

Fan speed50%Min 20%

Print speed40 mm/sStarting point

Retraction0.5 mmAt 35 mm/s

Nozzle0.4 mmbrass

Source: Derived. Based on manufacturer specifications.

Imports directly into OrcaSlicer via File → Import → Import Configs

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
PETG Generic	235°C 220–250°C	80°C 75–90°C	50% /20%	40 mm/s	0.5 mm @ 35 mm/s	Derived

PETG is hygroscopic — dry your filament before printing if stored openly for more than a week.
Reduce fan speed to 25–50% for better layer adhesion. Too much cooling causes layer delamination.
Use a higher first-layer height (0.25–0.3 mm) and reduce first-layer speed for better adhesion.
PETG sticks aggressively to PEI — use a thin layer of glue stick or hairspray as release agent.