What temperature for PETG on the Artillery Sidewinder X4 Plus?

Recommended nozzle temperature for PETG on the Artillery Sidewinder X4 Plus is 235°C (range: 220–250°C). Bed temperature: 70°C.

What bed temperature for PETG on the Artillery Sidewinder X4 Plus?

Set the Artillery Sidewinder X4 Plus bed to 70°C for PETG. The acceptable range is 65–80°C.

Use 1.3 mm retraction distance at 40 mm/s for PETG on the Artillery Sidewinder X4 Plus.

Set the part-cooling fan to 40% for PETG on the Artillery Sidewinder X4 Plus. Minimum speed: 10%.

Print PETG at 235°C nozzle and 70°C bed on the Artillery Sidewinder X4 Plus.Fan speed 40%, retraction 1.3mm, print speed 60mm/s.

Nozzle temp235°C220–250°C range

Bed temp70°C65–80°C range

Fan speed40%Min 10%

Print speed60 mm/sStarting point

Retraction1.3 mmAt 40 mm/s

Nozzle0.4 mmbrass

Source: Official profile. ✓ Verified against official profile.

Imports directly into OrcaSlicer via File → Import → Import Configs

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Artillery PETG Artillery	235°C 220–250°C	70°C 65–80°C	40% /10%	60 mm/s	1.3 mm @ 40 mm/s	Official profile

PETG is hygroscopic — dry your filament before printing if stored openly for more than a week.
Reduce fan speed to 25–50% for better layer adhesion. Too much cooling causes layer delamination.
Use a higher first-layer height (0.25–0.3 mm) and reduce first-layer speed for better adhesion.
PETG sticks aggressively to PEI — use a thin layer of glue stick or hairspray as release agent.