What temperature for PETG on the Artillery Sidewinder X1?

Recommended nozzle temperature for PETG on the Artillery Sidewinder X1 is 235°C (range: 220–250°C). Bed temperature: 60°C.

What bed temperature for PETG on the Artillery Sidewinder X1?

Set the Artillery Sidewinder X1 bed to 60°C for PETG. The acceptable range is 55–70°C.

Use 0.5 mm retraction distance at 40 mm/s for PETG on the Artillery Sidewinder X1.

Set the part-cooling fan to 90% for PETG on the Artillery Sidewinder X1. Minimum speed: 40%.

Print PETG at 235°C nozzle and 60°C bed on the Artillery Sidewinder X1.Fan speed 90%, retraction 0.5mm, print speed 60mm/s.

Nozzle temp235°C220–250°C range

Bed temp60°C55–70°C range

Fan speed90%Min 40%

Print speed60 mm/sStarting point

Retraction0.5 mmAt 40 mm/s

Nozzle0.4 mmbrass

Source: Official profile. ✓ Verified against official profile.

Imports directly into OrcaSlicer via File → Import → Import Configs

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Generic PETG Generic	235°C 220–250°C	60°C 55–70°C	90% /40%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

PETG is hygroscopic — dry your filament before printing if stored openly for more than a week.
Reduce fan speed to 25–50% for better layer adhesion. Too much cooling causes layer delamination.
Use a higher first-layer height (0.25–0.3 mm) and reduce first-layer speed for better adhesion.
PETG sticks aggressively to PEI — use a thin layer of glue stick or hairspray as release agent.