ABS settings for the SV06 Plus
Print ABS at 245°C nozzle and 100°C bed on the SV06 Plus.Fan speed 20%, retraction 0.5mm, print speed 40mm/s. Note: this is an open-frame printer — a draft shield or enclosure accessory is recommended for ABS.
Recommended settings (0.4 mm brass nozzle)
Nozzle temp245°C230–260°C range
Bed temp100°C90–110°C range
Fan speed20%Min 0%
Print speed40 mm/sStarting point
Retraction0.5 mmAt 35 mm/s
Nozzle0.4 mmbrass
Source: Derived. Based on manufacturer specifications.
Imports directly into OrcaSlicer via File → Import → Import Configs
0.4 mm nozzle
| Filament | Nozzle temp | Bed temp | Fan | Speed | Retraction | Source |
|---|---|---|---|---|---|---|
| ABS Generic | 245°C 230–260°C | 100°C 90–110°C | 20% /0% | 40 mm/s | 0.5 mm @ 35 mm/s | Derived |
Tips for printing ABS on the SV06 Plus
- ABS warps significantly without an enclosure — this printer is open-frame; use a draft shield or enclosure accessory.
- Minimize fan cooling — high fan speeds cause layer cracking in ABS.
- Increase bed temperature gradually if warping occurs: try 105–110°C.
- ABS fumes — print in a ventilated area.