What temperature for PLA+ on the Elegoo Centauri Carbon?

Recommended nozzle temperature for PLA+ on the Elegoo Centauri Carbon is 225°C (range: 200–235°C). Bed temperature: 60°C.

What bed temperature for PLA+ on the Elegoo Centauri Carbon?

Set the Elegoo Centauri Carbon bed to 60°C for PLA+. The acceptable range is 55–70°C.

Use 0.5 mm retraction distance at 40 mm/s for PLA+ on the Elegoo Centauri Carbon.

Set the part-cooling fan to 100% for PLA+ on the Elegoo Centauri Carbon. Minimum speed: 60%.

Print PLA+ at 225°C nozzle and 60°C bed on the Elegoo Centauri Carbon.Settings below cover 4 nozzle sizes (0.2mm, 0.4mm, 0.6mm, 0.8mm).

Nozzle temp225°C200–235°C range

Bed temp60°C55–70°C range

Fan speed100%Min 60%

Print speed60 mm/sStarting point

Retraction0.5 mmAt 40 mm/s

Nozzle0.4 mmbrass

Source: Official profile. ✓ Verified against official profile.

Imports directly into OrcaSlicer via File → Import → Import Configs

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Elegoo Rapid PLA+ Elegoo	225°C 200–235°C	60°C 55–70°C	100% /60%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Elegoo Rapid PLA+ Elegoo	225°C 200–235°C	60°C 55–70°C	100% /60%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Elegoo Rapid PLA+ Elegoo	225°C 200–235°C	60°C 55–70°C	100% /60%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Elegoo Rapid PLA+ Elegoo	225°C 200–235°C	60°C 55–70°C	100% /60%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

PLA+ prints like PLA but requires 5–10°C more nozzle temperature for full strength — start at the recommended 225°C.
Keep fan at 80–100% for best layer bonding and bridging performance.
PLA+ is stiffer and less brittle than standard PLA — good for functional parts that don't need high heat resistance.
If you see elephant's foot on the first layer, raise the Z offset slightly or reduce first-layer flow to 95%.