What temperature for ABS on the Elegoo Neptune 3 Plus?

Recommended nozzle temperature for ABS on the Elegoo Neptune 3 Plus is 245°C (range: 230–260°C). Bed temperature: 100°C.

What bed temperature for ABS on the Elegoo Neptune 3 Plus?

Set the Elegoo Neptune 3 Plus bed to 100°C for ABS. The acceptable range is 95–110°C.

What retraction settings for ABS on the Elegoo Neptune 3 Plus?

Use 0.5 mm retraction distance at 40 mm/s for ABS on the Elegoo Neptune 3 Plus.

What fan speed for ABS on the Elegoo Neptune 3 Plus?

Set the part-cooling fan to 0% for ABS on the Elegoo Neptune 3 Plus. Minimum speed: 0%.

Elegoo › Neptune 3 Plus

ABS settings for the Neptune 3 Plus

Print ABS at 245°C nozzle and 100°C bed on the Elegoo Neptune 3 Plus.Settings below cover 5 nozzle sizes (0.2mm, 0.4mm, 0.6mm, 0.8mm, 1mm). Note: this is an open-frame printer — a draft shield or enclosure accessory is recommended for ABS.

Nozzle temp245°C230–260°C range

Bed temp100°C95–110°C range

Fan speed0%Min 0%

Print speed60 mm/sStarting point

Retraction0.5 mmAt 40 mm/s

Nozzle0.4 mmbrass

Source: Official profile. ✓ Verified against official profile.

Imports directly into OrcaSlicer via File → Import → Import Configs

All nozzle sizes

0.2 mm nozzle

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Elegoo ABS Elegoo	245°C 230–260°C	60°C 55–70°C	40% /0%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

0.4 mm nozzle

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Generic ABS Generic	245°C 230–260°C	100°C 95–110°C	0% /0%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

0.6 mm nozzle

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Generic ABS Generic	245°C 230–260°C	100°C 95–110°C	0% /0%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

0.8 mm nozzle

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Generic ABS Generic	245°C 230–260°C	100°C 95–110°C	0% /0%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

1 mm nozzle

Filament	Nozzle temp	Bed temp	Fan	Speed	Retraction	Source
Generic ABS Generic	245°C 230–260°C	100°C 95–110°C	0% /0%	60 mm/s	0.5 mm @ 40 mm/s	Official profile

Tips for printing ABS on the Elegoo Neptune 3 Plus

ABS warps significantly without an enclosure — this printer is open-frame; use a draft shield or enclosure accessory.
Minimize fan cooling — high fan speeds cause layer cracking in ABS.
Increase bed temperature gradually if warping occurs: try 105–110°C.
ABS fumes — print in a ventilated area.

Recommended settings (0.4 mm brass nozzle)