Anycubic Kobra 3 MaxTPU settings

Slicer settings for printing TPU filament on the Anycubic Kobra 3 Max. Nozzle temperature, bed temperature, fan speed, retraction, and print speed — sourced from official slicer profiles.

Recommended settings (0.4 mm brass nozzle)

Nozzle temp225°C210–240°C range
Bed temp65°C60–75°C range
Fan speed100%Min 100%
Print speed60 mm/sStarting point
Retraction0.8 mmAt 40 mm/s
Nozzle0.4 mmbrass

Source: Official profile. ✓ Verified against official profile.

All nozzle sizes

0.4 mm nozzle

FilamentNozzle tempBed tempFanSpeedRetractionSource
Anycubic TPU
Anycubic		225°C
210–240°C		65°C
60–75°C		100% /100%60 mm/s0.8 mm @ 40 mm/sOfficial profile
Generic TPU
Generic		225°C
210–240°C		60°C
55–70°C		100% /0%60 mm/s0.5 mm @ 40 mm/sOfficial profile

0.6 mm nozzle

FilamentNozzle tempBed tempFanSpeedRetractionSource
Anycubic TPU
Anycubic		225°C
210–240°C		65°C
60–75°C		80% /50%60 mm/s1 mm @ 40 mm/sOfficial profile

0.8 mm nozzle

FilamentNozzle tempBed tempFanSpeedRetractionSource
Anycubic TPU
Anycubic		225°C
210–240°C		65°C
60–75°C		80% /50%60 mm/s0.5 mm @ 40 mm/sOfficial profile

Tips for printing TPU on the Anycubic Kobra 3 Max

  • Print TPU slowly (20–30 mm/s) — the flexible nature causes feeding issues at high speeds.
  • Disable or minimize retraction to prevent grinding. Direct-drive extruders handle TPU much better than Bowden setups.
  • Dry TPU filament before printing for consistent results and to prevent stringing.